5 Alternative Hanging Solutions for Lath and Plaster Walls. We’ve just done a bunch because we are refinancing but then there are more on the list to hit before winter. 4 Installation Tips for Curtain Rods on Lath and Plaster Walls. Would look ghetto af but less work haha.įor under $50 I’m willing to give the repeater a go first and see if I can keep another house project off our list. I guess we could always drop it into the closet and run it out into the hall. But otherwise it would involve a lot of twists and turns to get it somewhere better. My GF is already not stoked on the idea of trying to drop a wire–however–we think we might be able to drop it straight the floor into the closet under the stairs which isn’t ideal. I’m surrounded by wood paneling and am probably in the worst position in the house from where the router is but we can’t move it for a couple of reasons tied up in my partner’s thin client, HIPPA (she does medical billing) so technically I can’t be upstairs while she is working. Some old houses even used chicken wire in the walls, effectively turning beach room into a Faraday cage. We aren’t sure if it is dry wall or plaster. If the house still has the lathe and plaster walls, it could be a challenge even with the best mesh wifi. We call it our “doll house.” But it is quite old. Upgrading to one from the ‘all-in-one’ routers you get from your ISP is like driving a Cadillac after being stuck in a Camry. These things are used for wifi on college campuses everywhere, so they’re robust and easy to set up. So great that depending on your house layout and construction, you might be able to just hang it above the router and get good coverage everywhere. I’ve got one of the ones I linked above that services a 3700 sqft two-story, lathe-and-plaster house (as well as out into the yard) - the coverage and penetration is great. Couple of small holes and 30 minutes in the attic gets you whole-house coverage that you never have to worry about again. That’s not nearly as hard as it sounds if you have a drill and a little time - drill in the corner of the room with the router, run a cable thru the ceiling to a mid point in the house, connect one end to the router and one to the access point. The real way you fix this is to run a wire and put in an access point. These things are seriously YMMV, as they don’t fix a bad signal or do much in terms of penetration of dense wood/metal/etc construction. The trick is to place it half way or so through the house as it has to get the signal from the router, and hope it covers the rest of it. Something like this or this (an upgraded version that handles faster signal) would probably do. That’s a unit that takes the existing signal and ‘reamps’ it, boosting the signal into another part of the building. Simplest would be what’s called a wifi repeater or extender. Also, what’s the house layout and how old is it? Trying to beam through old construction is considerably harder than drywall. What kind of wireless router do you have? The kind of signal you’re putting out will determine what you need to fix it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |